In the same manner, when you’re building a 30 amp generator extension cord, you have to twist the exposed wires of all three conductors at both ends. Lightly separate the three wires at each end of the cable, then use the wire stripper to strip them. Strip the hot, neutral, and ground wires, then twist them together Strip both ends, one of which will be wired to the plug and the other to the receptacle. Use any tool you see fit – for some, good, old scissors will suffice, while for others, wire strippers work better. Next, stripping the cable’s insulation is a must for any standard extension cord or generator cord, as you need to expose the conductors inside for attaching later. Unless you’re creating a 30 amp RV extension cord 100 ft, for which you can buy cables for exactly that length, you have to cut the cable to match your intended coverage for the extension cord. Cut the cable to the appropriate length, then strip the ends Again, you just have to make sure you’re using the wire with the correct weight relative to the amp values. These steps still apply to cords with that amperage as well. It’s OK to use a 220 volt one instead if you’re trying to make a 50 amp RV extension cord. Lastly, a typical travel trailer 30 amp extension cord needs a 120 volt outlet. Once the run reaches double that or 20 feet, then it’s better to take it up a notch by opting for an 8 gauge wire (or 8/4 wire to be exact) instead. By default, if you’re just making a short 30 amp RV cord that’s around 10 feet long, then it’s OK to use the standard 10 gauge wire rated for 600V. Note: Regarding the wire you choose, make sure the size suits the entire run you intend to use the camper 30 amp extension cord for.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |